Description

An insert for female USB leads to go into one of the empty control spaces in a 2006 Subaru Impreza WRX. The gap in the middle should be enough for two female leads to fit snugly. This was created to set up a tidier way of containing the leads from an Atoto A6, rather than just having them hang down under the centre console. It should fit the base Impreza as well, but I don't believe the STI has the required empty control space (you get fun stuff like diff lock controls instead). Print Settings Printer Brand: Creality Printer: CR-10S Rafts: No Supports: Yes Resolution: .16mm to 23mm height, .08mm above that Infill: 30% (probably overkill) Filament: Rigidink PLA Notes: I set the layer height to .08mm from 23mm high, just to make sure the slight curve on the top of the insert was as smooth as possible. .16mm/layer below that, so it didn't take forever. I printed it in the orientation it is, letting Simplify3D automatically set supports. Category: Automotive