Description

I was frustrated with failing suction cups, adhesive, and vent clips so I designed this mount to clip directly to the trim of my 2017 RAV4.  Uses a standard  17mm ball joint, so it should fit the majority of phone mounts and chargers on the market.  I used a MagSafe charger for my S24 Ultra and it works great. Print in PETG or something heat resistant.  I used 5 perimeters, 25% infill for strength. I recommend splitting it into parts and gluing together to avoid supports.  I've provided a pre-split 3mf to make this easy. I was able to remove the trim easily by hand pulling on the far right side, but if that's not the case for you use a trim removal tool to avoid damage.  (There are several 3D printed versions available if you need them.)  Don't force the clip over the trim.  It should slide easily if you start from the left side.