Description

I used PLA+ with 0.12mm layers and 0.4mm nozzle. No support or adhesion. Any infill fine. This is my less-used plip so I didn't bother doing much tidying up on the top of the buttons, just a bit of light sanding and polishing, so the angled layers are still just visible but that doesn't bother me. At less than 1p to print the lock and boot buttons (the unlock on mine was still fine) I could redo the job later if I really wanted to, and might even use different colours just for fun :o) The unlock and boot buttons are actually slightly different sizes (boot is smaller) but the unlock button size happens to fit still, it just needs to face the opposite way so the fatter bit points towards the centreline of the plip.