Description

ATTENTION! Version 1.0 did not hold very well. One of the clips was deformed after some time. I think it could be because of the PLA, but I don't really know yet. I used another solution now.  BUUUUT: I made a small improvement and released version 2.0. I don't know if that's a better solution so I need some feedback from you. Yes, YOU. I needed a new Blind Plug for a 2002 Toyota Avensis T22 because the old one is not perfectly flat and I wanted to mount a holder for the garage door opener on it. I just put the 2 parts together with double side adhesive tape because i think it's easier to print as 2 parts. If you only want to use it as Blind Plug you can use the textured sheet for better looks. I did NOT remix this but I want to credit because it was my inspiration  "Bracket for Eazymatic garage door opener" by "olidub" https://www.thingiverse.com/thing:4539075 It is for the left side of the steering wheel. Directly between the switch for the Mirror adjustment and the switch for the headlight adjustment. Print instructions Printer: Prusa Mini Filament: Recommend something more temperature resistant then PLA. (PETG, ABS, ASA?) Layer Height: 0.2mm Quality Setting in PrusaSlicer Infill: Doesn't really matter because it's more perimeter then infill. Supports: No