Description

Extended another design for a trunk hook by 2cm at the stem to better accommodate access to the hooks. The bottom of the hooks have slightly problematic overhangs, so I enabled supports from build plate. --v3 Should not required supports I also printed this using adaptive layer heights to improve layer adhesion on some of the object interface points, while also maintaining a reasonable print time. I'd recommend PETG or better for anything that has to endure the heat that can build up in a car trunk, however I originally printed it with PLA+ (Inland) and used it throughout the summer without issue. Changelog: July 30, 2025 Uploaded a version 3 that is printable without supports, based on another design that's credited in the remix section. A much better way to handle steep overhangs compared to my v2, which I will now delete. Jan 31, 2021 Uploaded a version 2 that has a maximum overhang of 60 degrees Print instructions Print Settings Printer Brand: Prusa Printer: I3 MK3S Rafts: Doesn't Matter Supports: Yes* Resolution: 0.15 (Adaptive) Infill: 40% Notes: Minimum 3 perimeters. Gyroid Infill. * v3 does not require supports.