Description

Tesla 3 Highland turn signal lever design. I recommend using PTG, ABS filament. Do not use PLA. After printing, visible elements should be sanded and painted. Use four small strips of foam (5mm x 5mm x 12mm) to help the lever return to the center position better. There is a place prepared for this in the housing. You need two S3XY BUTTONS to operate: https://enhouto.com/ You will also need double-sided tape to stick the lever in the car. Use good quality so that it does not peel off. Short movie: https://youtu.be/GzSh3E6bUF0?si=OJGYysF7ZqmCKR1v