Description

This is just a fun rendition of the original katakana emblem. If you will be putting it on a car don't use pla. The sun will likely warp it depending on the type of pla. Common sizes below. These measurements are from out side edge to outside edge so you should be able to rescale in your slicer pretty easily.  100mm x 69mm x 8mm 110mm x 76mm x 8mm 113mm x 79mm x 8mm 118mm x 81mm x 8mm  120mm x 83mm x 8mm 127mm x 88mm x 8mm 130mm x 90mm x 8mm 140mm x 97mm x 8mm  150mm x 104mm x 8mm