Description

Safety warning Do not use consumer-grade/desktop 3D-printing for this application unless you anneal the prints in an oven. Industrial grade 3D printing may be OK but Laser cutting or CNC milling HDPE plastic up to 12.5mm (1/2") is best. Anything thicker than 12.5mm (1/2") ought to be milled steel or aluminum from a service like https://www.sendcutsend.com. Introduction Just a few Subaru suspension spacers you can use to make part of a lift kit or fix a saggy rear-end. You don't need to spend hundreds on Amazon for a lift kit anymore! In general, spacers up to ~6mm (1/4") do not need longer studs to be installed between the strut top and chassis.  For anything thicker, you'll probably need to install longer studs or switch to aftermarket strut tops. Mount styles (A) Rear 2-stud (Legacy/Outback/Baja 2000-2009) Baja 2003-2006 Legacy/Outback 2000-2009 (B) Rear 3-stud (Legacy/Outback 1995-1999, Impreza 2002-2007, etc.) Forester 1998-2002 Impreza 2002-2003 Legacy/Outback 1995-1999 Probably fits: Forester 2003-2008 Impreza 2004-2007 Saab 9-2X 2005-2006 STI 2004-2007 WRX 2002-2007 (C) Front 3-stud smaller (Impreza, BRZ, FRS, GR86, etc.) Baja 2003-2006 BRZ/Scion FR-S/Toyota 86/GR86 2013-2025 Forester 1998-2008 Impreza 1993-2007 Legacy/Outback 1990-2004 Saab 9-2X 2005-2006 Probably fits: Outback 2010-2019 (D) Front 3-stud larger (Legacy/Outback 2005-2009, WRX, STI, etc.) B9 Tribeca/Tribeca 2006-2014 Crosstrek/ XV Crosstrek 2013-2017 Forester 2009-2018 Impreza 2008-2016 Impreza R 2009-2012 Impreza Sport 2008-2011 Legacy/Outback 2005-2009 STI 2014-2022 WRX 2014-2022 Probably fits: STI 2008-2013 WRX 2008-2013 Todo I need photos/measurements to design additional spacers: stud diameter (typically 12mm or 14mm) distance between studs (center to center in mm) diameter of central circle/oval that houses bearing or fits into strut turret any other external measurements top-down photo 1990s rear 3-stud style Legacy 1990-1994 Impreza 1993-2001 2008-2019 rear 2-stud style Ascent 201