Description

Best printed in ASA to prevent warping in the heat. PETG works fine too. The .gcode file is optimized for a Prusa MK4. Works with Apple Magsafe Charging Pucks, JSAUX MagSafe pucks, and Mophie Charging Pucks - those are the three we've tested to work for sure. It's a VERY snug fit by design. I found that inserting the pucks was best done by getting them as far in as possible with the non-corded end sitting up a bit, then taking a folded up towel and putting it on top of the pucks, then a swift tap with a hammer would pop them right in without damaging anything.