Description

The only issue with my R1T properly charging was preventing the phone from slipping forward or slantways on the charging pad.   This fits my Pixel 6 and my wife's Pixel 7 (and similar sized phones).  Simply ‘press’ the tabs into the recess on the factory charge pad area and it will otherwise sit flush and maintain itself.   Ideally, print with a material that will not be sensitive to temperature (PETG, Nylon, ASA, etc).  but since this sits relatively flat, there's not much risk that even PLA would be a problem, as warp doesn't tend to occur in any meaningful way (at least in my experience).   If you need dimensions changed for a different phone form factor, just send me a message with your phone's overall length + width (include any cases you have in that dimension) and I'll spin something up for you. EDIT 20240104: I was alerted to the fact that I failed to upload STEP or STL files!  Oops! They're attached for your convenience--if anyone needs anything else, including modifications, please reach out.  Have a great day!