Description

🎁   Get $100(s) in Rivian Rewards points and 3 months free RAN charging by using my  referral code   TODD11893313  when  🛒 ordering a Rivian . UPDATES Feb 18, 2025 The divider STLs now include two separate bodies to more easily control the infill settings. The design is identical to before, but this simplifies the slicer controls.  If you import the raw STL, you can “split into parts” in your slicer.  Alternatively, load the PrusaSlicer .3mf. Overview A remix of Rob's console dividers for the Rivian R1S/R1T.  I added more slots to give me more options.  I also made the clips a little bit sturdier and smaller.  I added notches everywhere so you don't have to care which orientation the clip is. The original goal of remixing is so I could have more options to figure what orientation I found most useful.  In playing with the original version, it has a notch on the “back” intended for the safety manual to sit on.  I found it cumbersome and wanted to address that.  I found that by adding more adjustability, I could use two front-to-back dividers on the outermost slots and fit the safety manual (or other paperwork) between them. I also discovered that printing the original models with solid walls made them almost too rigid. I wanted a little bit more flex to them, so instead I printed them with only gyroid infill and some solid strips on the top/bottom edges.  This gives them a nice amount of flexibility and makes them feel “softer”. NOTE: The pictures are of a slightly older version of my models before I had notches on the tops for the clips and before I shrunk the clips from 20mm to 15mm diameter.  If I get around to printing again, I'll update the photos. Printing See the .3mf, which includes all of the following settings for PrusaSlicer… clips 5 perimeters to make it solid outer part of dividers 7 perimeters inner part of dividers 15% gyroid infill 0 perimeters 0 bottom layers 0 top layer