Description

Updated 06/23/20: v3 has a relocated arm to keep the body from pressing on the Panamera's armrest and a little more room "cut out" at the top of the body to make removing the phone more easy. Updated 05/27/20: v2 has a better angle for the arm, refined body to hold phone and make it easier to remove, MUCH better base that fits ashtray better. Introduction There's no attractive and functional phone holder for the Porsche Panamera (especially if you don't want to use adhesives and trip clips). It's a niche project, but works exceptionally well... and who needs an ashtray anyway?! This is compatible with 2010 - 2016 Panamera models (970.1 and 970.2) and is designed for my Asus ROG Phone II (hey, I said it was niche...), but could be modified easily as the phone holder body is just a box. The holder BASE and WEDGE should be printed in TPU or FLEX and are simply inserted into the ashtray. No clips, no adhesive, no modifications to your car. The TinkerCAD is maintained here: v1: https://www.tinkercad.com/things/2BlIoSTxllE . v2: https://www.tinkercad.com/things/c62ldRzIpXI Printing Instructions: Print the WEDGE in TPU or FLEX. I used clear TPU from SAINSMART. Printing with a .10mm layer thickness works well. Print bottom-down (normal orientation). No supports are needed. Print the BASE in TPU or FLEX. I used the same SAINSMART TPU. I recommend printing at a relatively large layer height. Either .20 or .30mm leaves nice ridges on the sides that seem to grip the ashtray nicely. Print top-down (slot facing down) and you won't need any supports. Print the ARM in something heat appropriate. PLA might get a little flexy in hot climates. I used ABS for the latest version, but PETG works in cooler climates (keep in mind tolerances and material shrinkage if you use ABS). Print upside down with supports, with the mounting face on the print bed and the supports for the screw recesses will be minimal. I printed without supports while testing and the results were acceptable, but I wan