Description

986 GT3 Center Console Delete The split file is to fit on a Prusa Mk3s Recommend using PETG Must remove orange tabs on the bracket to mount Left enough room to upholster part Fit as one part on Prusa XL. Used PETG with organic supports. Used 3mm brim since part is thin and long, but would recomend atleast double that at 6mm. It started to detach near outer thinnest corners. Didnt impact the print, but would prefer perfect results :) I am going to wrap this in the below carpet. Have heard that it being 2mm thin in many areas with the carpet shrinking over time causing warping. Will test this out and release revision if it needs to be thicker. Likely 3-4mm walls.   carpet suggestion: https://gahh.com/ https://www.upholsterysupplyusa.com/ https://trufitauto.com.au/product/plush-pile-meterage-off-the-roll-1mtr-wide