Description

This was originally a project for adapting a Megasquirt 3 Pro (Gen 1) ECU to the mounting panel in my 944 Turbo. It's called the Megasquirt Interface & Layout Frame (M.I.L.F.) However I'm uploading a few different versions, so others can make their own. MS3Pro + 14Point7 Megaspartan Wideband (needs 400 x 400mm printer) MicroSquirt V3 (smaller size, should fit on most printers) MS1, MS2, MS3 / MS3X, universal bolt pattern with slotted holes. (Also smaller size, should fit on most printers) The above are very specific and it's more likely that you would need to make your own. To address that, the following files are released in Solidworks (SLDPRT), STEP, and STL formats: Generic full-size bracket. A large printer is required here. Start with this if you are aiming to mount multiple items in the ECU location (fuse panel, wideband controller, some relays, etc.) Generic half-size bracket. This is the best choice if you are just mounting a small ECU and don't need a lot of space. It should fit on most printers. For both of the above, you'll need to add your own mounting geometry for your specific ECU or whatever you are trying to mount here. These files have good measurements of the metal panel that the original DME / KLR mounts to. The orientation may be confusing. While this obviously prints horizontally, you should pay attention to which side and which end is where. Need a reference? Look at the MS3Pro model. The main ECU mounting area with the 4x holes is positioned upward and to the left, as viewed from the installed position. Some notes: Some ECUs, including the Microsquirt and MS3Pro, have harness plugs which exit at 90 degrees to the ECU instead of being inline. This can clash / foul with the sheet metal of the firewall because there's not a lot of space back there. This is the reason why the MS3Pro and Microsquirt files have the ECU position higher up - to take advantage of the space that is available, without over-bending the wiring. If your ECU is similar, sugg