Description

You can use any 15mm, 17mm or 1 inch ball attachment to add a phone/accessory mount or charging to your dash.  It clips in the decorative channel between the screens with a little pressure. This model is inspired by the mounting meathod created by RWerksman at   https://www.thingiverse.com/thing:5427851   However, I designed this new model from scratch with a more secure fit in mind and a raised mounting point to avoid the steering wheel blocking the phone.  It’s pretty solid considering how tall it is. I recommend printing vertically with ASA (PETG will work, but can deform in a hot car) due to the flexibility needed when installing.  Add a modifier to the top ball and ball arm to make it 100% infill in the top section so it doesn't warp when pressure/weight is added.  I used 30% infill for the mid-section and 10% for the bottom section.  Reference the GCODE files to view where I put infill modifiers or just use them for your prints!  It sounds complicated, but I promise it's an easy print! To install, push the base in until it snaps behind the center screen. I personally am using a MagSafe charger attached to an adhesive female ball mount.