Description

OpenSourceEV Parts designs, produces, and retails 3D printed parts for Rivian EVs. We're Open Source because we post the STL files for every single product that we design so everyone can remix or 3D print them at home for little to no cost. We're committed to enhancing the Rivian Owner community and promoting 3D printing through our natively open approach.  If you are considering purchase a Rivian R1S or R1T, you can both get $500 worth of Rivian Gear, 6 months of free RAN charging, and support our mission of making Open Source enhancements for them by using our Rivian Referral Rewards code - ROBERT1265188 . You enter this code when putting your deposit down on your Rivian. Details are available here . +++ This item is a mat that will hold up to 2 OEM Apple MagSafe pads on top of pad covering the POS wireless charger built into the Rivian R1T or R1S Center Console.  Installation is simple - insert the Apple MagSafe pad into the hole while aligning the plug in the right direction. Attach to the rubber pad via double sided tape. The pads will be kept in place by friction. It's recommended that you remove your phone from the charger at an angle to ensure they stay put.  Print in PETG or ABS top side down. A textured bed is recommended to get the same finish as shown in the picture. Supports were not needed for me and will likely not be for you as the overhangs are minimal. This product is not available for sale on OpenSourceEV.com as the Ultimate pad kit was produced instead.