Description

Super simple design, should work with all Mazda 6's from 2012 onwards.   In my country the Mazda6 still needs the phone to be plugged in by cable for the Apple Carplay to work, the obvious place to put your phone is in the drink holder…..but where do your coffees go….? Bazinga!  this super simple print wil allow you to clip your phone in the space around the inside of the consol.  You wont be able to close the lid with the phone in there, but hey…I never have. Tested on iPhone X, XS and 11 in cases. Print in PETG, ABS or ASA.  NOT PLA+ as is will warp horribly.  Supports not needed, I have alligned the clip to print with the single piece facing upwards, if not, just rotate it or print on its side. Simply push it into the slight gap as in the pictures below.  Its a tight fit :) Please like this model!