Description

This is a frame to hold an Anker PixelSnap/Magsafe Qi2 wireless charger in the center console of any pre-2022 facelift Porsche Macan without the smoker package.  If you have a lid on your center console, you have the smoker package, and this won't fit. There are other models out there which are probably better for most use cases, but I wanted to hide all of the electronics, and I needed my phone to sit a little further forward, away from the cup holders. The model puts ~1mm of plastic between the charger and phone, which wasn't enough to significantly affect charging speed in my testing. The magnets could be stronger, but my phone hasn't slipped yet. If you need to reduce the thickness, you can sink the cover into your build plate in your slicer. I was only able to test this with a Pixel 10, but as far as I can tell, this is compatible with iPhones with magsafe. Parts List 4x   M3x8mm bolts 1x    Anker Zolo Qi2 USBC Charger 1x   USBC 12v Car Charger, as low profile as you can find. I used this one but it doesn't matter much. 1x   Sheet of stick-on felt/flocking from a craft store. You only need a 2x27cm strip of it. 1x   3x5mm magnet (3mm tall, 5mm diameter) 1x   Cover printed in ABS, sanded and acetone-smoothed 1x   Frame printed in ABS Printing/Assembly Instructions Use ABS for the entire project. Print the cover first. Orient it face-down on your printer to avoid any bridging artifacts. Direct your slicer to put the seams along the top edge, which will face the front of the car so you won't see them as often. Sand the cover smooth with 180grit sandpaper. I should have done another round of this in my build, you can still see some of the texture in my pictures. Use acetone to smooth the cover even further. You could also vinyl-wrap the cover and use the frame to secure things, but I haven't personally tried this. Check the correct orientation for your 3x5mm magnet by holding it against your