Description

I printed it from PETG (3 perimeters) and sandpapered. O-ring sizes, which I used: Recommended material FPM75 (Viton). Smaller: ID:25mm TH2.5mm Bigger: ID:27mm TH2.5mm ---------------------------------------------------------------------------------------------------- Also recommended to fit bush and check the collapsible tube…..

Advertisement — Non-personalized

Comments (0) · ★ 0.0 (0 ratings)

Sort by

No comments yet — be the first.

Indexed from Printables

Land Rover LT230 intermediate shaft O-ring install tool

by Indexed from PRINTABLES

0.00 views0 downloads2026-09-10

I printed it from PETG (3 perimeters) and sandpapered. O-ring sizes, which I used: Recommended material FPM75 (Viton). Smaller: ID:25mm TH2.5mm Bigger: ID:27mm

Save

Report this part·IP report

License

CC BY-NC 4.0

Files

Open on source site