Description

Just a new gear knob, it fits the Slickshift from Syncrogearboxes for the Series. You just need to fine cut the bottom with a little knife and press it on. I added one with the original Land Rover logo, on a request. Print Settings Printer: Velleman K8200 Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: As fine as you want, but i reccomend you paint it after. Infill: I used 60% Cubic Filament: Prima Filament PLA Notes: I used 2mm walls and 1mm top and bottom. You should use thicker top and bottom as it will greatly enhance the parts where it hangs a lot. Category: Automotive