Description

General This is a replacement for the rubber corner for the Land Rover Series and early Defender B- and C-Pillar (part number 33215). Commercial replacements are available but as you need 4 or 6 for each vehicle, printing can be cheaper. The original rubber is very soft, so I recommend you to get the softest TPU available to you and printable on your printer.   Versions “Neutral” - Both sides are equal like the original part. You can print the same parts for all corners. “Corner Specific” - These models are skewed to the angle of the side walls, resulting in a nicer fit. But they are not universal anymore and you have to print all four for the four corners.   Print Settings Use TPU or other flexible filament (as soft as possible) Infill depending on TPU hardness, 90-100% is probably desireable to avoid too much “squishing”   Special thanks to https://www.printables.com/@CasperMeyhoff_710172 for providing measurements and photos for replicating this part 👍 Please consider liking and posting a make if you find this useful 🙂