Description

Jensen JC7DM There is a version specific to the Jensen JC7DM. It attaches to the slide mount that comes with the unit. This version prints nicely without supports. Generic I made the other version for my dad to use a suction cup mount. Note that he had to sand and spray paint the top surface in order to make the gel like suction cup to stick. This version needs a lot of support. If I were to do it again, I would make it in two different sections and glue together. Printing I recommend: ABS/ASA - something heat resistant. I made a prototype out of PETG and it folded like a taco in the heat. 40% infill Brim (inner and outer) At least 4 walls / ceilings / floors