Description

A Simple 2 peice (to make it easily universal for other makes) UHF microphone holder mount for the Ineos Grenaider - mounts in existing holes on the upper row of Dials 2 Peices - A universal Dash mount and a manufacturer specific adaptor plate.  2 Versions - Left hand Side (of centre console) mounted designed for RHD vehicles Right hand Side (of centre console) mounted designed for LHD vehicles However either could be used on either LHD or RHD  Currently supports the following Mic holders Ecoxgear Magnetic mount GME Magnetic and non magnetic mount (tested by others as I dont have the mount to check) Uniden - waiting on dimensions I printed from CF PETG - It should hold up to a summer. I printed at 0.12mm layer heights but you should be able to vary this a bit if you want to go thicker. Supports only needed on counterbored screw holes - or use Orcaslicer and use the counterbore hole printing function. (see screenshots for orientation) 3 or 4 M3 Heatset inserts are required to be inserted - I prefer inserts to tapping the print. 2x M3x10 or 12 Button head screws for joining the parts and M3 screws for fixing the mic mount. For fixing to the vehicle you will need M4x16 low head cap screws if you want to match the look of the original screws on the centre console. These can be had from various nut and bolt outlets or aliex (the aliex ones have a smaller hex than the factory ones) I also added some very thin foam under the mating face to the dash so as to stop any potential rubbing. The Mic does not seem to interfere with the passengers legs (for the LH Mounted version in a RHD vehicle) and is easily within my arms length (I am around 6ft)