Description

Designed this to fit a glowshift tachometer but it should fit any 52mm gauge. I wanted the print to come out cleaner so I split it into two halves. The hardware I used to combine them: 2x M3 - 5mm Threaded inserts 2x M3 - 6'ish mm Bolts As a result of needing the inserts the wire opening hole is only 7mm wide resulting in the plug for my tach not fitting. I got around this by just depining the plug, running them through and repining. I'll include an untested file if you wish to print this as one unit to allow a larger wire opening Plug in and install the gauge, it is just press fits in. My gauge was a little loose so I wrapped it one time in tape. I recommend making sure your gauge is rotated the way you want it to be. The front clip that locks the vent is not the strongest and is prone to snapping off if you torque on the gauge wrong. You can now snap the vent in place. Printed in ASA Feel free to print in any orientation I printed the vent with the top facing the build plate with no supports, and the gauge face down with supports.