Description

I removed the grab handle from the driver's side of my Kona N because it hit my helmet when autocrossing the car. This left two ugly holes in the headliner. This piece plugs the holes. I only tested this on the Kona N, but I think the handle is a standard Hyundai part, so it will probably work on other Konas and Hyundais. Print it with the flat side down, no support needed. I used Eco-ABS with 0.1mm layers and 100% infill on a Dremel 3D45, because my Prusas were busy. But I think a wide range of printers, materials, and settings would work. You will need two flathead screws, M6 x 16mm. This matches the exposed thread length on the original grab handle fasteners. You could probably use a screw as short as 8 or 10 mm and still make it work. Fusion 360 Model Link