Description

This is 2010 - 2014 Mustang seatbelt Presenter Arm.  I used more strength points and tried to make it an OEM easy replacement. OEM uses ABS material, but I suggest using ASA, and it came out great without printing issues and designing problems. Do not print it with PLA, it will distort because of the weather, and crack the little spring head inside. It seems to print better if you print it in the same face, touching the bed as the picture shows below, with the inner teeth touching the bed.  supports required. Use Snug for better finishing.  use 10% - 15% infill (it needs to be a bit elastic or it will break. I also attached the spring head, if you need it, which sets inside the arm, use support for it.