Description

This is a generic phone holder that goes into the cubby hole FITS slot adapter I intend for this to be used with my pixel 3/4 phones but you can modify the dimensions to fit your phone / case. I printed this on a Creality Ender 3 with eSUN PETG using the following settings: Print Temperature: 245 Plate Temperature (Initial Layer): 80 Plate Temperature: 70 The rest of my settings were autoapplied via the eSun Black PETG with 0.4mm nozzle extruder settings in Cura 4.13. Print time total was 8 hours 21 minutes. Fitment was tested in the cubby hole FITS adapter and the rear FITS slot. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: Yes Supports: Yes Resolution: 0.2 Infill: 20% Filament: eSun PETG Black, Orange Category: Automotive