Description

Using Brad Bauer's door handle facia as a base for dimensions, all I did was slim it down slightly, and add 1.9mm tabs all around. This was all done in the slicer so don't come for me! lol Note, I test fit this on my own Fisker Ocean Extreme and while it is a tight fit, that is absolutely on purpose. This will keep the handle firmly in place and perfectly centered for a clean install. I would HIGHLY recommend ONLY printing this in PLA to ensure good dimensional accuracy. Sure beats paying $30 for one of these!  Since this is basically a one-time-use throwaway tool, I didn't feel like wasting extra time and even more filament on designing tabs to grab for removal as that would also require supports and blah blah blah, so this is as simple as it gets. It's not hard to remove as-is, but if you find it fiddly, just get a piece or ribbon or string and place it between the handle and the tool lengthwise sticking out both sides when you install it, so that way you can use it to pull it off clean and easy. Again, I don't think it's necessary, but just an option.