Description

I was missing one of my door bumpers, so I created a new one with some improvements to keep it from falling out.       Printing Tips Use flexible like TPU or TPE (I used TPE) Print at 10% infill Use cubic infill pattern (this had more flex over grid) Make sure retraction speed is low (i.e. 20mm/s)   Installation Tips Squeeze where indicated in the diagram below Push tip into hole in door at a slight angle and twist while holding pressure on the bumper The bumper should work its way into the hole.  I found if I printed this at too high on an infill percentage, the bumper was impossible to insert into the door, because it was too stiff.