Description

This is a deeper model that I just made. It has a slanted floor to hold your glasses to the rear. You can put your glasses or coins in here to keep them in place. The side with more depth goes towards the shifter.  I put a thin piece of rubber mat in the bottom of mine to keep things from sliding. This goes in the console in front of the shifter. I did not need any two sided tape on the bottom, but you might need some if it does not snap in. Not sure it will work with all models, I have a 2018 SR5 and cup holder can still be used. If you want one that is not so deep go here. https://www.printables.com/model/370321-5th-gen-4runner-sunglasscoin-holder I print this standing up with supports to the build plate only. Use PETG or better because of the heat in a car.