Description

About This is an insert for the driver's side dashboard shelf on Renault Twingo 2nd generation cars, for left-hand drive variants. If you have a right-hand drive Twingo you may need to mirror the model. The model is derived from a photogrammetry scan I did on a dashboard spare part myself, it's not modelled from scratch. It is a bit rough and uneven along the walls, but the bottom is modelled/replaced to be completely flat. In the picture I added a “RAM Mount B-Size Ball Mount” by LongleafWorkshop ( https://www.printables.com/model/247512-ram-mount-b-size-ball-mount ) in the slicer software, it's not part of this model. Be aware though if you intend to use it for a phone mount, make sure to secure it properly, it may otherwise tip over while accelerating or braking. Printing It's a fairly large model at about 25 cm in width. I cut the insert at the dividing wall in Orca Slicer and added 5 mm plug connectors. Make sure to add some tolerance for the plugs and holes, depending on your printer's print quality. The photo was printed in Sunlu black PETG on an A1 Mini with support enabled, with the short part printed upright. I reworked the top edges and support connections a little with a deburring tool and sandpaper.