Description

My truck did not come with the installed options at the bottom of the dash, only empty fillers. Normally on higher trim levels these locations would be used for the trailer brake buttons and an inverter outlet. There is nowhere good in the truck to mount my phone holder and its mount broke so I saw an opportunity to solve two puzzles with one print. Took 4-5 iterations before I arrived at a clip design that clipped in well. If you are gentle these can be removed by gently sliding the whole filler up until the bottom clips are clear. The left has a blank filler that you can modify for your own uses as well as a version with a ~17mm ball for the style of phone mount I have (see pictures, available on AliExpress). The right filler has one completely blank version and one with an arrow on the back, although the up/down orientation probably does not matter at all. Photos of the left filler are included with my employer's logo blurred out. Figured they can't complain about mods if they have the company logo on them. These were designed for SLA printing and work quite well with good ABS-like or "Tough" resins but should be possible to print on an FDM printer as well.