Description

Here are some protective covers for your CCS/J1772 to NACS charging adapters.  I only have access to the ones from Rivian, so that's what I've included so far.  If I end up with others I'll add more or at least verify if these fit.  They're meant to protect the internal connectors from damage and let you just throw your adapter into your frunk or anywhere else you want to store it. All of these use some form of friction to hold in place. The NACS cap has a spring/tab that engages with the lock notch of the connector to help hold it in place.  It does not fully latch so you can just slide it back off. The J1772 and CCS cap walls have a 1 degree taper inward and should hold pretty well once you slide them on.  As these fit pretty tight, use a non-abrasive filament like just plain PETG/ABS/ASA.  Avoid glass-fiber or carbon-fiber variants or your adapter might become scratched after repeated use. The dust caps should be a nice snug fit.  Most likely they'll fit any J1772 or CCS adapter, but the dimensions seem to vary slightly so YMMV. Printing I use PETG, which has been fine.  You might consider ASA for better heat resistance. No supports (though there's a small bridge on the nacs caps to be aware of) Print the nacs-cap-clip  on it's side for proper strength. I used 0.4mm nozzle and 0.20mm layers 3 perimeters Support If you like my models and want to make my day , you can buy me a ☕ !