Description

Made this tool to install the rear output seal on a TR6060 Tremec 6mt found on a 2004 Cadillac CTSV. I messed up the first seal and pushed it too far into the transmission as there is no machined lip to stop it. Then I designed this tool. Has a 70 or 72 mm base with a 40mm opening. I used a 30mm socket with a hammer to install. This will set the seal flush with the case of the transmission. WAY better than the way I did it the first time. I used supports touching the buildplate with 15% infill, very easy to remove. Printed overall with 70% infill at 0.3 resolution. Takes hammer blows like a champ, should be good enough to loan to a friend after you finish using it. Second design ever, saved my butt.