Description

This is a replacement visor clip for a 2022 Audi A5 Quattro. It's possible that it might also work for other models or other model years. However, the only vehicle this has been tested on is the 2022 Audi A5 Quattro. Materials required In addition to the printed parts, the following materials are required. Super glue: required to adhere the individually printed parts together Clip cover: recovered from the existing visor clip Metal spring: recovered from the existing visor clip Small screw driver: required to remove the existing clip from the car Parts The Base This part forms the base of the clip. All other parts, including the clip cover and metal spring, attach to this. The Hook The car's visor snaps into the space between this and the metal spring. The Legs (large and small) These, along with the clip cover, secure the clip to the roof of the car. Print settings Printer Type An FDM printer is recommended. Resin printed parts might not have the tensile strength necessary for the clip to function as designed. Material All parts should be printed with ABS, or an equally strong material. Perimeters & Top/Bottom Layers Two perimeters and four top/bottom layers should be used. Layer Height The base and legs should be printed with 0.2mm layer height. The hook is the only part visible once installed and should therefore be printed at the smallest layer height the printer supports. Infill Density The base and legs should be printed with 15% infill. The hook should be printed with 70% infill. Supports The large and small legs already have supports necessary to print. No additional supports are required. Elephant Foot Compensation This model has been designed to provide some resilience to elephant foot. However, if the printer introduces significant elephant foot, the parts may not fit together without filing or cutting away excess material. It is highly recommended that elephant foot compensation be set to a large enough value to completely eliminate all elephant foot. Ir