Description

My phone mount is for an air vent, however it's always been quite sloppy due to the fact that the mount moves. So this gives a solid fixed point for it to grab onto. It's definitely over built, and can be trimmed down if you really want to save 5g of filament from the 27g that it currently is (.STEP is provided). No supports Recommend ASA/ABS print Central connection can be edited as required. Installation Using a plastic lever (e.g. dash trim tool, or a bicycle tyre lever), work the centre vents out from the dash, basically pry them around the circumference bit by bit until you can pull them out with your hand. Put the vents through the holes and then push them back in.