Description

Description  2023-2024 Subaru Ascents have 19 cupholders. All of them are too small for my 40oz Thermoflask container as well as most soda fountain cups here in the United States. The cupholders between the driver and passenger seats have four stabilizing prongs to hold drinks steady. This design has slots to fit into those prongs in order to prevent the insert from coming out with your drink. Additional holes were added to around the outer cup to allow for easy airflow when inserting and removing your Thermoflask.  Available Variants The prongs on the front cup holder are spaced slightly differently from the rear cupholder. There is an STL file for a front and rear insert. The rear insert will fit in both the front and rear cup holders, but won't be as stable.  Print instructions print settings: 0.20mm 15% Grid infill. Supports may be necessary for overhangs.  print material : PETG or any filament that can handle summer heat in an automobile.  Changelog 03/2024 - Initial version 1.0 (R1) 25/03/2024 - Added a variant for the front model without the horizontal slot openings. I found that it makes removing the insert nearly impossible without damaging the insert. The two vertical slots should keep it stable and still allow the insert to be removed without damage.  26/04/2024 - Added a variant that has thicker walls for the inside of the base of the insert. This should be a stronger option and less prone to break when removing the insert. This insert should fit in both the front and rear cup holders. Due to the wall thickness, certain larger gas station/convenience store cups will not slide into the insert. If you want to go big, you have to print thin.