Description

  ABOUT THIS MODEL:  2022 Subaru BRZ Fog Light Brackets for Diode Dynamics SS2 SAE Fog Lights  After 2 months of development and 5 revisions of this design, I now have the “final” revision printed and mounted on my 2022 Subaru BRZ (as of this posting - 2 months of use). I was bummed there was no options out there for auxiliary lighting on my BRZ, and I was especially bummed about not having fog lights from the factory after really loving the look (not the output) of the OEM fogs on the first generation (2013-2021). This is my first ever 100% designed from scratch 3D model. As with any and all modifications to a vehicle, I (Mark Breeden) accept no responsibility for any accidents, injuries, citations by law enforcement, complaints, law suits, damages, or failures caused by anyone attempting to use this design for their vehicle or anyone else's.  ***** USE THIS DESIGN AT YOUR OWN RISK *****   NO DRILLING REQUIRED on the vehicle These fog light brackets “wrap around” the vertical grill slats in the BRZ bumper. When these brackets are combined with the Diode Dynamics Stage Series 2 (aka - SS2), they are fully adjustable left-to-right and up-and-down. I was able to angle these to cut-off just below my headlight cut-off,  and they have served me very well.    SLICING AND PRINTING I printed the in Overture PETG in Black on my Anycubic Kobra (standard). The design is fairly resistant to variations in printing temperature, layer height, and printing speed. However, I recommend printing it as slowly as possible for the best look on the front side of the verticals which can be seen once you are all done. I sliced this in Prusa Slicer, and I used their “organic” tree supports to help with the overhangs. My Parameters: Elmers Glue on PEI Sheet PETG was dehydrated to below 30% relative humidity Layer Height - 0.3mm Perimeters - 3 (minimum) Infill - Gyroid at 20%) Top Layers - 4 Bottom Layers - 4 Supports - Organic 0.2 Top (detachable) 0.1 B